How Many Lbs Should Compressor Be To Shoot Finish Nails

Welcome dorsum for some other Tool Tutorial Friday! Today I'1000 going to introduce you to a 2 gallon compressor and pneumatic finish nailer.  I utilize the Campbell Hausfeld 2 gallon compressor with Pneumatic Cease Nailer. I bought these as a kit when they were on sale at Lowe'south for $69! A expert price on this gear up is $89. There are loads of other brands out at that place and I'k sure they have other features and capabilities, but bluntly I've been happy with my set up that I've had for two years. Other kits tin can toll up to $300. The only drawback with this set is that they tin can not exist used for framing (building walls of a house structure.) But, then far I oasis't needed to do that.

The cease nailer works very well on moulding, trim, board and batten, wainscoting, and other small-scale wood projects.

How to Use a Pneumatic Finish Nailer and Air Compressor

The compressor is a fairly simple tool. When turned on, air builds upwards in the chambers until information technology reaches the maximum 110 psi.

The pressure level going into the air hose can be controlled by the regulator button. I typically use my compressor and nailer at about 90 psi. Merely, if the nails are going also far into the woods, I might turn it downwards to 80 psi. Or if the nails aren't going in far enough I will plough information technology up to 100 psi. With continual use, the pressure will driblet down. When the pressure is low enough, the compressor volition start itself back up to raise the pressure once again.

The on/off switch on my compressor is in the back.

The end nailer holds pocket-sized brad nails up to two″ in length and "U" shaped staples. They are held in the mag. The safe tip on the nailer must be pressed into the wood before a nail will fire. Otherwise, the gun will not belch.

While using the nailer and compressor information technology is very important to use condom goggles and ear protection.

When you are finished using the compressor, information technology is important to release all the air from the compressor. If y'all don't release the air, wet tin build up and rust the tank. Showtime past reducing the pressure by turning the regulator down. So pull the safety valve ring. Information technology volition close automatically, so yous will need pull it a few times or agree it open. I also unscrew the valve at the lesser of the tank to insure information technology is completely empty before storing. Then I screw the valve back in.

After the tank is empty, release the hose from the nailer. Add a drop or two of penetrating oil onto and in the air inlet on the nailer to keep it well lubricated. Cover the air inlet and and so you tin can store your nailer and compressor.

DISCLAIMER

The viewer assumes all responsibility and liability associated with the hazards of woodworking. Pretty Handy Girl is not responsible for whatsoever errors or omissions that may exist present in this tutorial. She also assumes no liability for any activity or inaction of a viewer.

Please use farthermost caution when using power tools. Read your tool manual thoroughly and wearable protective safety gear. Take your time familiarizing yourself with a tool earlier using information technology. (If you lot are missing the transmission, you can easily find it online by going to the manufacturer's website or google your saw'southward brand and model + manual.)

Please recognize that I accept tried to put together a basic finish nailer and compressor tutorial to get yous started. I have tried my best to show the safest way to use them. That being said, I am not a professional (I just play one on this blog .)

Without further ado, here is the tutorial video:

Source: https://www.prettyhandygirl.com/how-to-use-a-compressor-and-finish-nailer-tool-tutorial-friday/

Posted by: sikoraeaddelartion79.blogspot.com

Share this post